Original Insta360 Bullet Time Cord For (ONE X2 / ONE R / ONE X / ONE)
 
The Bullet Time Cord for the Insta360 ONE X2 camera lets you rotate the camera overhead in Bullet Time mode.
 
Fasten into the 1/4 "-20 thread on the bottom of the camera, pull out the 43" wire along its retractable length, and then swing the camera over your head in a circular motion.
 
The rubber ring on the bottom of the 1/4 "-20 screw ensures that there is no damage to the bottom of the camera where the 1/4" -20 threaded hole is located.
 
Make sure the cable is fully extended during use (110cm / 43 inch)
Rotate overhead in a smooth, steady motion. For best results, use Bullet Time mode in bright outdoor environments.
Double check that you have attached the Bullet Time Cable properly before use.
Use a rubber housing to prevent damage caused by the 1/4 '' screw port. Do not disassemble the rubber case during use.
 
In The Box:
1 x Insta360 Bullet Time Cord